Vapogard AC220

A high performance anti-carbonation coating for exterior and interior application over a suitably prepared substrate as per Terraco anti-carbonation systems.

Phương pháp thi công: Phun

Tổng quan sản phẩm

Vapogard AC220 is superior quality 100% pure acrylic water based anticarbonation coating, suitable for use on exterior and interior surfaces of concrete, plywood, antirust primed steel, etc. Vapogard AC220 protects concrete from carbonation (anti-carbonation coating) and provides outstanding protection to substrate against UV rays.

Vapogard AC220 is available in selected exterior range of colours and can be applied by brush, roller, airless or conventional spray.

Đặc tính

Vapogard AC220 contains materials which provide excellent weather and pollution-resistant properties, as well as precisely graded special fillers to ensure the coated surface always maintains its original decorative beauty. Vapogard AC220 has a matt finish when dry.

Khu vực sử dụng

Vapogard AC220 can be used on new or old surfaces of concrete, brickwork, plasterwork, plywood, galvanized steel and anti-rust primed steel. It is suitable for housing developments, industrial and commercial complexes, bridge facades, girders and roof trusses, site cabins, etc.

It is widely used as anti-carbonation coating for basement car park walls and ceilings.

Phương pháp thi công

Preparation of Surface:

New surfaces: Ensure that all dust, dirt and foreign matter are scraped and brushed away. Also ensure the surfaces are free from salts, oil, grease and ridges. Protect all adjacent surfaces not to be covered. All cracks, chips, voids and damages should be repaired with Terraco Handycoat Fine / Handycoat Stucco Putty (for interiors) / Handycoat Exterior (for exteriors)

Old surfaces: Before applying to old surfaces, ensure the substrate is firm. First wash down the surface with a sugar soap solution, rinse and allow to dry before repairing or applying the primer.


Dusty and flaking surfaces should be primed with Terraco Penetrating Primer.

Application and cleaning of tools

Very porous substrates should be filled and may require a diluted first coat. Apply the coating by brush, roller or spray in 2 -3 coats allowing 2 -4 hours drying time between coats. The application operation should be continuous in order to avoid dry edges; therefore plan the application work accordingly.

Clean tools and equipment with water after use.